Combo Unit, Industrial, Self-Testing, Damp Location, Dual Circuit Products (2 items)

Exit sign combo units are really a 2 for 1 solution and are the ideal solution where you need to install both an exit sign & an emergency light near each other. Exit combos allow you to maintain just one battery and unit while meeting two code requirements. There is a combo exit sign for almost every application and location.

Industrial modern blends the urban edge of utilitarian design with the warmth of aged woods and worn textures. Lighting utilize aged iron and metals with rich patinas, accented by weathered woods and soft neutral surfaces.

This feature may be added to many exit sign and emergency light fixtures, the SDT feature prolongs battery life, and reduced man hours required OSHA tests. Self testing diagnostic automatically executes a 15 minute test every 30 days and runs a 90 minutes test once per year. The major reasons batteries typically fail is because they remain dormant for long periods of time. With the SDT feature automatically simulates a full discharge and full recharge to keep the batteries in peak performance. If any problems arise during this testing process it will report them through the user interface. This benefit drastically reduces man hours required by OSHA to manually perform the tests.

A damp location is an interior location normally subject to dampness or condensation, or an exterior location protected from weather and not subject to saturation with water. Damp locations include over bathtubs, indoor pools, covered porches, and like locations.

Dual circuit exit signs. These unit allows the fixture to have dual power feeds. The idea behind this is so that when on normal power, the fixture is fed from a switch leg and can be turned off by the occupant. The PTS relay coil is fed by unswitched normal power. The normal power from the switch leg is connected to the normally open contacts on the PTS relay.