CEMXTE Thermoplastic Exit Sign

Exit signs save lives in case of fire or disaster. If your building loses power, exit signs with battery backup can guide people to safety. We sell a variety of exit signs to comply with building fire & insurance codes. If you are looking for a heavy duty wet location exit sign for outdoor placement or just looking to save some money with an energy efficient LED exit sign, we have it for you.

The main housing of these exit signs and emergency lights is painted white or made from a white thermoplastic.

The main housing of these exit signs and emergency lights is painted black or made from a black thermoplastic.

Federally approved high temperature 4.8 Volt exit sign and emergency lighting NiCd batteries. A 4.8 Volt NiCd has four AA, AAA, C, Sub-C, D or F cells in a battery pack that can come in a variety of configurations. Most common are cube, row and stick configurations.

Red letters are required for New York City and Chicago approved exit signs.

Green letters are typically used in theater exit signs.

A damp location is an interior location normally subject to dampness or condensation, or an exterior location protected from weather and not subject to saturation with water. Damp locations include over bathtubs, indoor pools, covered porches, and like locations.

Remote capable exit signs or emergency lights allow the unit to add additional lighting with remote light heads without adding additional fixtures.

Custom wording exit signs or signage can increase safety in the work place. Point people to the proper emergency location or areas to avoid when hazardous equipment is in use. Add your custom wording during the checkout process or call us at 763-542-3155 to place your order.

Products displaying an 'Assembled in the USA' label will contain a percentage of imported components but will be physically assembled in America and are compliant with the Buy American Act (BAA). The FTC states that Assembled in America products must have undergone a significant transformation on American soil.

This feature may be added to many exit sign and emergency light fixtures, the SDT feature prolongs battery life, and reduced man hours required OSHA tests. Self testing diagnostic automatically executes a 15 minute test every 30 days and runs a 90 minutes test once per year. The major reasons batteries typically fail is because they remain dormant for long periods of time. With the SDT feature automatically simulates a full discharge and full recharge to keep the batteries in peak performance. If any problems arise during this testing process it will report them through the user interface. This benefit drastically reduces man hours required by OSHA to manually perform the tests.

Visibility, brightness and long life are very important factors that should be thought about when purchasing and exit sign. Light emitting diode or LED exit signs & emergency lights have proven to be successful in the reducing electricity consumption by up to 85%. LED exit signs can save money and power while still emitting considerable amounts of light.

An emergency light with battery backup capability switches to emergency operation in the event of a power loss to illuminate escape routes and safety equipment.

These products can be hung from the ceiling. Many exit signs come with the ceiling mounting canopy included.

Exit signs & emergency lights that are surface mountable are typically one sided and have a back plate that can be connected directly to a wall or flat surface.

Dual circuit exit signs. These unit allows the fixture to have dual power feeds. The idea behind this is so that when on normal power, the fixture is fed from a switch leg and can be turned off by the occupant. The PTS relay coil is fed by unswitched normal power. The normal power from the switch leg is connected to the normally open contacts on the PTS relay.